10 Dec
2018
10 Dec
'18
9:13 p.m.
Hi Nik,
On Monday 10 December 2018 19:33:50 Dr. Nikolaus Klepp wrote:
Am Montag, 10. Dezember 2018 schrieb Baron:
Absolutely nothing, but if I plug in a USB stick I get this,
[ 7258.600228] usb 1-1.1: new high-speed USB device number 3 using
ehci-pci
[ 7258.694671] usb 1-1.1: New USB device found, idVendor=1aa6,
idProduct=0201
[ 7258.694676] usb 1-1.1: New USB device strings: Mfr=1, Product=2,
SerialNumber =3
[ 7258.694680] usb 1-1.1: Product: USB 2.0 Flash
[ 7258.694683] usb 1-1.1: Manufacturer: USB
[ 7258.694685] usb 1-1.1: SerialNumber: 05100846020087
[ 7258.745210] usb-storage 1-1.1:1.0: USB Mass Storage device detected
[ 7258.745352] scsi6 : usb-storage 1-1.1:1.0
[ 7258.745408] usbcore: registered new interface driver usb-storage
[ 7259.745916] scsi 6:0:0:0: Direct-Access USB USB 2.0 Flash
1.00 PQ : 0 ANSI: 0
[ 7259.746137] sd 6:0:0:0: Attached scsi generic sg2 type 0
[ 7259.746987] sd 6:0:0:0: [sdb] 127104 512-byte logical blocks: (65.0
MB/62.0 M iB)
[ 7259.747756] sd 6:0:0:0: [sdb] Write Protect is off
[ 7259.747759] sd 6:0:0:0: [sdb] Mode Sense: 03 00 00 00
[ 7259.748356] sd 6:0:0:0: [sdb] No Caching mode page found
[ 7259.748357] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 7259.754413] sdb: sdb1
[ 7259.757635] sd 6:0:0:0: [sdb] Attached SCSI removable disk
[ 7260.385411] FAT-fs (sdb1): utf8 is not a recommended IO charset for
FAT files ystems, filesystem will be case
sensitive!
When I remove it this line gets added.
[ 7902.788999] usb 1-1.1: USB disconnect, device number 3
Does this help ?
--
Best Regards:
Baron
Hi Dan, Guys,
On Monday 10 December 2018 16:59:25 Dan Youngquist wrote:
What does dmesg say when plugging in? On 12/08/2018 12:23 PM, Baron wrote:
I will try that option !
However I think I've killed my USB - HDD adaptor ! Non of the
machines that I have now even recognise that I've plugged the
thing in. That's two desktops and my laptop. The ports are OK
since they all recognise my USB sticks.
I'll order a new one and try again. If I have a HDD connected via a USB adaptor,
I've found that
after an initial plugging and use, then safely removing it,
going back to it, in the same session, it may or may not be
recognised.
I've always had a similar problem when using Safely Remove.
The solution is to use Unmount rather than Safely Remove; then
you can mount & unmount it as many times as you like with no
problems.