24 Dec
2016
24 Dec
'16
11:37 a.m.
Ló Béla wrote:
The screenshot is only partially visible. There is no master channel. It
reports as Audigy2, so quite messy
If there is no information, as this is the alsa project page, it would mean
it is probably not supported. So why would someone in TDE be able to help
you. You better ask for help in the ALSA project/user list.
Can you do a
proper screenshot please? I enjoy the tiger, but it is not
the subject of the question.
What exactlty you would like to see? My problem is shown on the picture,
the KMix panel shows the wrong PCM channel: capture instead of playback.
To me it looks
like false mapping. Perhaps you must provide the correct
model setting to your audio driver if it is supported >
Identify your card here
http://www.alsa-project.org/main/index.php/Matrix:Vendor-Creative_Labs
and write back with exact model. The one you cited (SB Audigy Rx) is not
in the list.
I have this exact card:
https://ipon.hu/webshop/product/creative_sound_blaster_audigy_rx/530747
You can get the model by lspci | grep Audio if it
is pci card or better
cat /proc/asound/cards
root@Csabi:~# lspci | grep Audio
01:00.1 Audio device: NVIDIA Corporation GK208 HDMI/DP Audio Controller
(rev a1)
The SB card does not appear like this. I do not use this at all and it
does not appears if i hit F6 in alsamixer.
root@Csabi:~# lspci | grep audio
06:00.0 Multimedia audio controller: Creative Labs SB0400 Audigy2 Value
With small "a" the SB card appears but my card is not an Audigy 2.
root@Csabi:~# cat /proc/asound/cards
0 [Audigy2 ]: Audigy2 - SB Audigy 2 Value [Unknown]
SB Audigy 2 Value [Unknown] (rev.0,
serial:0x10241102) at 0xaf00, irq 18
ALSA does not recognize the Rx card?
From the screenshot I assume you have: Sound
Blaster Audigy2 ZS Value, so
perhaps this here helps:
http://www.alsa-project.org/main/index.php/Matrix:Module-emu10k1
I don't understand. How this helps me, there is no information in this
article about the Audigy Rx false recognition as Audigy 2. The soundcoure
module is exists at my machine.
However a quick search shows that other people has
this problem too:
I would bet they have
https://forums.linuxmint.com/viewtopic.php?t=199401But
i have no problem
with the sound or the MIDI, everything works fine, it's just an
erroneous channel show in KMix. This article says it needs additional
firmware:
http://www.linux-hardware-guide.com/in/2014-08-26-creative-sound-blaster-au…
i install the Rx firmware? I installed
alsa-firmware-loaders, but i have
no firmware to the Rx. - TCH
Yes install the firmware and go to the ALSA people looking for further help.
regards