Dne čt 16. července 2015 Nigel Henry napsal(a):
My usb harddrive will not open the plugged media
notifier on Precise 12.04
with TDE 3.5.13.2.
If I log out and back in to the xfce4 desktop the usb harddrive is detected
and mounts ok.
I also have Lucid 10.04 with TDE and Hardy 8.04 with KDE3 on the same
machine and the plugged media notifier works ok on them.
On a new machine I have recently installed Precise 12.04 with TDE 3.5.13.2
which installed with no problems whatsoever (Asrock M3A785GM-LE/128M) and
the plugged media notifier works as expected.
On the Precise 12.04 with the problem, I ran tail -f /var/log/syslog and
the usb harddrive is detected ok and shows the two partitions on it as
below.
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.180024] usb 1-7: new
high-speed USB device number 4 using ehci_hcd
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.248237] hub 1-0:1.0: unable
to enumerate USB device on port 7
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.704028] usb 2-7: new
full-speed USB device number 4 using ohci_hcd
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.904956] usb 2-7: not running
at top speed; connect to a high speed hub
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.934473] usb-storage 2-7:1.0:
Quirks match for vid 152d pid 2329: 8020
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.936142] scsi7 : usb-storage
2-7:1.0
Jul 7 12:30:28 ubuntu-desktop mtp-probe: checking bus 2, device 4:
"/sys/devices/pci0000:00/0000:00:02.0/usb2/2-7"
Jul 7 12:30:28 ubuntu-desktop mtp-probe: bus: 2, device: 4 was not an MTP
device
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.944980] scsi 7:0:0:0:
Direct-Access WDC WD50 00AAKX-00ERMA0 15.0 PQ: 0 ANSI: 2 CCS
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.951726] sd 7:0:0:0: Attached
scsi generic sg6 type 0
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.958973] sd 7:0:0:0: [sde]
976773168 512-byte logical blocks: (500 GB/465 GiB)
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.971984] sd 7:0:0:0: [sde]
Write Protect is off
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.971989] sd 7:0:0:0: [sde]
Mode Sense: 28 00 00 00
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.984971] sd 7:0:0:0: [sde] No
Caching mode page found
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.984977] sd 7:0:0:0: [sde]
Assuming drive cache: write through
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.022515] sd 7:0:0:0: [sde] No
Caching mode page found
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.022519] sd 7:0:0:0: [sde]
Assuming drive cache: write through
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.042053] sde: sde1 sde2
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.110974] sd 7:0:0:0: [sde] No
Caching mode page found
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.110979] sd 7:0:0:0: [sde]
Assuming drive cache: write through
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.110983] sd 7:0:0:0: [sde]
Attached SCSI disk
Jul 7 12:30:54 ubuntu-desktop kernel: [ 5950.279533] usb 2-7: USB
disconnect, device number 4
^Cdjmons@ubuntu-desktop:~$
I get the same as the above with the new install of Precise 12.04 but then
the plugged media notifier opens and when I click on ok I get a few more
lines of output and the harddrive is mounted and opens the partitions in
konqueror.
Apart from reinstalling TDE default settings and the desktop has anyone any
suggestions as to how to troubleshoot the problem that TDE seems to have in
opening the plugged media notifier on this install?
Thanks in advance,
Nigel.
If I remember correctly, on Ubuntu Precise was sometime problem with the
proper functioning of HAL. And because notifications of the media in TDE
3.5.13.x depends on HAL, you must first verify the functionality of HAL.
...or you can upgrade to the TDE R14 series, which no longer needs to HAL.
--
Slávek