21 Aug
2018
21 Aug
'18
1:11 p.m.
On Tuesday 21 August 2018 03:20:43 Dr. Nikolaus Klepp wrote:
Am Dienstag, 21. August 2018 schrieb Gene Heskett:
I'll try that (mounting the old wheezy partitions as ext2) on the next
install, but first feed the missus.
--
Cheers, Gene Heskett
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
Genes Web page <http://geneslinuxbox.net:6309/gene>
On Monday 20 August 2018 10:41:23 Dr. Nikolaus
Klepp wrote:
Hi Gene!
When you cannot mount the ext4 partions from one another, then there
is something very wrong. ext4 can be mounted as ext2 and that should
alway work - at least, if the drives and filesystems are ok.
Nik Am Montag, 20. August 2018 schrieb Gene Heskett:
Its tears so far Nik. There are so many differences just in the
ext4's used that one of them should be renamed, they will NOT cross
mount, ext4 disk to ext4 mount. [...]
These guys make a pretty good installer simply because they know
what it needs and doesn't need to run LinuxCNC right. They don't
care if it doesn't run on cousin Molly's washing machine,
although with some config effort, it can probably run it, better
than the programming it came with.
I certainly had no such problems installing tde on top of the
kde I originally loaded onto my Dell running a grizzly G0704
mill on a special wheezy install. So I'll do the same and then
install tde on that.
Back later with grins or tears.
Thanks Michelle.
Hi Gene!
You should definitly walk the devuan road. I had a hell of a time
with machinekit on BBB, till I found out how to get rid of the
systemd stuff. When you run stretch + linuxcnc, you'll most likely
get bad surprises (aka. latency > 400000ns) with the 4.*-rtpreempt
kernel
Nik