21 Aug
2018
21 Aug
'18
3:20 a.m.
Am Dienstag, 21. August 2018 schrieb Gene Heskett:
On Monday 20 August 2018 10:41:23 Dr. Nikolaus Klepp
wrote:
Hi Gene!
When you cannot mount the ext4 partions from one another, then there is something very
wrong. ext4 can be mounted as ext2 and that should alway work - at least, if the drives
and filesystems are ok.
Nik
--
Please do not email me anything that you are not comfortable also sharing with the NSA,
CIA ...
Am Montag, 20. August 2018 schrieb Gene Heskett:
Its tears so far Nik. There are so many differences just in the ext4's
used that one of them should be renamed, they will NOT cross mount, ext4
disk to ext4 mount. [...]
These guys make a pretty good installer simply because they know
what it needs and doesn't need to run LinuxCNC right. They don't
care if it doesn't run on cousin Molly's washing machine, although
with some config effort, it can probably run it, better than the
programming it came with.
I certainly had no such problems installing tde on top of the kde I
originally loaded onto my Dell running a grizzly G0704 mill on a
special wheezy install. So I'll do the same and then install tde on
that.
Back later with grins or tears.
Thanks Michelle.
Hi Gene!
You should definitly walk the devuan road. I had a hell of a time with
machinekit on BBB, till I found out how to get rid of the systemd
stuff. When you run stretch + linuxcnc, you'll most likely get bad
surprises (aka. latency > 400000ns) with the 4.*-rtpreempt kernel
Nik