Which State is Trinity based in? I.e., where, in the most general terms, is
Timothy's server farm? (The USA is _too_ vague for my current discussion.)
(Of the weather.)
Lisi
My usb harddrive will not open the plugged media notifier on Precise 12.04
with TDE 3.5.13.2.
If I log out and back in to the xfce4 desktop the usb harddrive is detected
and mounts ok.
I also have Lucid 10.04 with TDE and Hardy 8.04 with KDE3 on the same machine
and the plugged media notifier works ok on them.
On a new machine I have recently installed Precise 12.04 with TDE 3.5.13.2
which installed with no problems whatsoever (Asrock M3A785GM-LE/128M) and the
plugged media notifier works as expected.
On the Precise 12.04 with the problem, I ran tail -f /var/log/syslog and the
usb harddrive is detected ok and shows the two partitions on it as below.
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.180024] usb 1-7: new high-speed
USB device number 4 using ehci_hcd
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.248237] hub 1-0:1.0: unable to
enumerate USB device on port 7
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.704028] usb 2-7: new full-speed
USB device number 4 using ohci_hcd
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.904956] usb 2-7: not running at
top speed; connect to a high speed hub
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.934473] usb-storage 2-7:1.0:
Quirks match for vid 152d pid 2329: 8020
Jul 7 12:30:28 ubuntu-desktop kernel: [ 5924.936142] scsi7 : usb-storage
2-7:1.0
Jul 7 12:30:28 ubuntu-desktop mtp-probe: checking bus 2, device 4:
"/sys/devices/pci0000:00/0000:00:02.0/usb2/2-7"
Jul 7 12:30:28 ubuntu-desktop mtp-probe: bus: 2, device: 4 was not an MTP
device
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.944980] scsi 7:0:0:0:
Direct-Access WDC WD50 00AAKX-00ERMA0 15.0 PQ: 0 ANSI: 2 CCS
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.951726] sd 7:0:0:0: Attached
scsi generic sg6 type 0
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.958973] sd 7:0:0:0: [sde]
976773168 512-byte logical blocks: (500 GB/465 GiB)
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.971984] sd 7:0:0:0: [sde] Write
Protect is off
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.971989] sd 7:0:0:0: [sde] Mode
Sense: 28 00 00 00
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.984971] sd 7:0:0:0: [sde] No
Caching mode page found
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5925.984977] sd 7:0:0:0: [sde]
Assuming drive cache: write through
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.022515] sd 7:0:0:0: [sde] No
Caching mode page found
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.022519] sd 7:0:0:0: [sde]
Assuming drive cache: write through
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.042053] sde: sde1 sde2
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.110974] sd 7:0:0:0: [sde] No
Caching mode page found
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.110979] sd 7:0:0:0: [sde]
Assuming drive cache: write through
Jul 7 12:30:29 ubuntu-desktop kernel: [ 5926.110983] sd 7:0:0:0: [sde]
Attached SCSI disk
Jul 7 12:30:54 ubuntu-desktop kernel: [ 5950.279533] usb 2-7: USB disconnect,
device number 4
^Cdjmons@ubuntu-desktop:~$
I get the same as the above with the new install of Precise 12.04 but then the
plugged media notifier opens and when I click on ok I get a few more lines of
output and the harddrive is mounted and opens the partitions in konqueror.
Apart from reinstalling TDE default settings and the desktop has anyone any
suggestions as to how to troubleshoot the problem that TDE seems to have in
opening the plugged media notifier on this install?
Thanks in advance,
Nigel.
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA512
Dear all,
from the R14.1.x series, double clicking on an empty area (i.e. not over an item) in Konqueror's listview or iconview
will navigate to the parent folder. This is a very useful shortcut when you are navigating through folders using
Konqueror and spare you from either having to move the mouse to the "Up" arrow or using Alt+Up on the keyboard.
The functionality will also be available on the nightly builds as soon as the code can be pushed and the build farm
has rebuilt tdebase. Due to the current r14.0.x building process, the code won't be pushed for a while though.
If you are interested, you can rebuild from the current tdebase GIT code and the attached patch.
Cheers
Michele
PS: it may be worth reminding another new functionality available from the R14.0.x series, which may have gone
unnoticed to most of you. If you are renaming a file in Konqueror using a listview widget (not the iconview - yet),
you can move to the next/previous item using Tab/Shift+Tab without exiting the "rename mode". This is useful when you
need to rename several adjacent files, since you do not need to press F2 -> rename -> Enter for each file but just do
F2 -> rename -> move to next/previous item -> rename [ -> move to next/previous item -> rename --- repeat as needed]
- -> Enter
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v2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=GLz9
-----END PGP SIGNATURE-----
Last Debian I installed on any of my own systems was Etch, until Friday, when
I did a network minimal, then added TDE. In a broad sense, only one thing
bothers me at this point, no sound. In openSUSE we have YaST2 for such things
as sound configuration, but in Jessie/TDE I haven't found anything that
helps. Trying to use Synaptic to figure it out isn't working, because its
scroller is worthless - it has no buttons to scroll only a line at atime, and
the scrollbar hopelessly overshoots trying to drag or click. TCC's Sound &
Multimedia isn't producing any sound or any clues as to why not. SMplayer
plays video but without sound. Is there some TDE tool not yet installed that
can configure sound, or do I need some as yet undiscovered Debian tool to
make sound work? https://wiki.debian.org/ALSA didn't seem to help at all. :-(
# dpkg-query | egrep 'alsa|libasou'
ii alsamixergui 0.9.0rc2-1-9.1
amd64 graphical soundcard mixer for ALSA soundcard driver
ii alsa-tools 1.0.28-1
amd64 Console based ALSA utilities for specific hardware
ii alsa-tools-gui 1.0.28-1
amd64 GUI based ALSA utilities for specific hardware
ii alsa-utils 1.0.28-1
amd64 Utilities for configuring and using ALSA
ii libasound2:amd64 1.0.28-1
amd64 shared library for ALSA applications
ii libasound2-data 1.0.28-1
all Configuration files and profiles for ALSA drivers
ii libasound2-plugins:amd64 1.0.28-1+b1
amd64 ALSA library additional plugins
# lsmod
snd_hda_codec_analog 13795 1
snd_hda_codec_generic 63181 1 snd_hda_codec_analog
snd_hda_intel 26327 2
snd_hda_controller 26646 1 snd_hda_intel
snd_hda_codec 104463 4
snd_hda_codec_generic,snd_hda_intel,snd_hda_controller,snd_hda_codec_analog
snd_hwdep 13148 1 snd_hda_codec
snd_pcm 88662 4 snd_hda_codec,snd_hda_intel,snd_hda_controller
snd_timer 26614 2 snd_pcm
snd 65244 9
snd_hwdep,snd_timer,snd_pcm,snd_hda_codec_generic,snd_hda_codec,snd_hda_intel,snd_hda_codec_analog
soundcore 13026 2 snd,snd_hda_codec
--
"The wise are known for their understanding, and pleasant
words are persuasive." Proverbs 16:21 (New Living Translation)
Team OS/2 ** Reg. Linux User #211409 ** a11y rocks!
Felix Miata *** http://fm.no-ip.com/
Hi all!
I'd like to make kmail save all encrypted mails decrypted. Is there a way to do this?
Nik
--
Please do not email me anything that you are not comfortable also sharing with the NSA.
Dr. Nikolaus Klepp
Einnehmerstraße 14
A-4810 Gmunden
Tel.: +43 650 82 11 724
email: office(a)klepp.biz
Sorry I didn't label it correctly.
--
Bro. Michael Henry
Associate Pastor
Monticello Christian Church
1 Timothy 1:15 "This is a faithful saying, and worthy of all acceptation,
that Messiah Yeshua came into the world to save sinners; of whom I am
chief."
Hi.
Upgraded to Jessie and 14, and everything seems to be working except...
I don't find the "Move file to..." "Copy file to..." context menu item
any more. It used to be under "File Manager", "Behavior", next to
"Include Delete in the context menu", but I don't find it now.
Sorry if this has already been discussed.
Curt-
--
The secret of happiness is freedom,
and the secret of freedom is courage.
- Thucydides
In the appearance tab in system settings, under GTK styles and fonts, under
the GTK3, it claims the theme engine isn't installed. I know I installed
it. I would like to get Synaptic to use the right theme because it does
look ugly.
This has happened on two machines, the one we use for a projector and the
laptop I'm currently on. Any suggestions to try?
--
Bro. Michael Henry
Associate Pastor
Monticello Christian Church
1 Timothy 1:15 "This is a faithful saying, and worthy of all acceptation,
that Messiah Yeshua came into the world to save sinners; of whom I am
chief."
Hello
I have encountered a problem trying to get wireless going with R14 and
Ubuntu 14.04. I installed it thru the wireless last night using the
mini.iso from Ubuntu. Then the wireless went down.
I finished installing TDE from a hard line. and the internet works
good on it. On the wireless side, the wireless is detected and
enabled, I can scan for networks and it detects my network.
The problem comes when I try to add a connection with
TDEnetworkmanager. It says "Unable to save network connection.
Potential causes: insufficient permissions, network manager not
running, DBus failure" . Networkmanager is installed and I have ran
TDEnetworkmanager as root. Still not connecting.
Any advice or help will be thankful.
--
Bro. Michael Henry
Associate Pastor
Monticello Christian Church
1 Timothy 1:15 "This is a faithful saying, and worthy of all
acceptation, that Messiah Yeshua came into the world to save sinners;
of whom I am chief."
